Skip to content Skip to navigation Skip to footer
INDIAN MOTORCYCLE
HELP CENTER
04/03/2024

2015-2024 Scout Battery Removal and Installation

Required Tools and Supplies: 

  • Shop Rags
  • Dielectric Grease or Petroleum Jelly
  • 10mm and 13mm Sockets
  • Ratchet
  • Torque Wrench

For more information on tools, read Tools and Fasteners Guide. Always wear safety glasses and nitrile gloves when servicing your Indian Motorcycle.

To remove and replace the battery on your Scout, Scout Sixty, Scout Bobber, Scout Sixty, Scout Bobber Twenty or Scout Rogue follow these steps:

1. Park the bike on a flat, level surface.

2. Ensure the key is turned OFF and removed.

3. The seat removal process varies by model. Remove the seat per your Owner’s Manual guidelines.

4. Then press the fuse box release tab inward. Slide the fuse box to the rear to remove it from the bracket. Position the fuse box out of the way, using care to prevent damage to the wires.

5. Using a 10mm socket, remove the negative battery cable first to prevent arcing. Position the cable well clear of the terminal.

6. Remove the positive protector boot from the positive battery cable. Remove the cable from the terminal with a 10mm socket. Position the cable well clear of the terminal.

7. Reinstall the fasteners onto the posts to prevent misplacement.

8. Then remove the battery bracket fastener with a 13mm socket and remove the bracket.

9. Tilt the battery slightly to the rear and lift it out of the motorcycle.

10. Inspect the battery box for damage.

11. Also, ensure the pads on the bracket are properly located and in good condition.

12. If reinstalling the battery, ensure it is fully charged and free of any debris or damage. Follow the instructions in the Battery Charging section of your Owner’s Manual before installing the battery. The replacement battery is part number 4017819.

13. Carefully position the battery into the battery box with the negative terminal toward the front of the motorcycle.

14. Reinstall the battery bracket. Torque to 84 in-lbs (9 Nm).

15. Route the positive cable perpendicular to the long side of the battery. Install the positive cable first to prevent arcing. Torque to 45 in-lbs (5 Nm).

16. Reinstall the positive cable protector boot.

17. Then install the negative cable. Route the cable perpendicular to the battery. Torque to 45 in-lbs (5 Nm).

18. Apply a light film of dielectric grease or petroleum jelly to both terminals.

19. Verify the cables are secure and properly routed.

20. Carefully reinstall the fuse box to the bracket, ensuring the release tab engages.

21. Turn the bike ON to verify the battery has been connected properly.

22. Finally, reinstall the seat per your Owner’s Manual guidelines.

For more information, see your authorized Indian Motorcycle Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Indian Motorcycle International, LLC.
© 2022 Indian Motorcycle International, LLC