Some 2022 and newer Chief models and 2023 FTR models are equipped with the 4" Round Touchscreen Display powered by RIDE COMMAND, shown below.
For an orientation to the display and its functions, watch the video below.
For more information on the touchscreen buttons, see the table below.
Press the Screen Cycle button to toggle through available display screens.
Press the Controls button to access vehicle and display settings.
Press the App Tray button to access the settings and phone screens.
Press the Back button to back out of menus and screens.
The Icon Bar displays information such as cell signal strength, current Ride Mode and more.
Press the Screen Cycle button (1) or the trigger switch on the left hand control to cycle through the available display screens.
Displays important information such as speedometer, tachometer, gear, vehicle direction, ambient temperature, odometer and fuel level.
Displays bike information such as ambient temperature, battery voltage, tire pressure, fuel economy and fuel range.
Displays ride information such as ride time, distance, elevation and trip odometer.
Maps and Navigation
Provides access to maps and turn-by-turn navigation.
Select audio source and control audio playback.
Select Ride Mode and change display brightness.
Display Screen Themes
There are two display screen themes to choose from: Standard and Analog Sport. The display screen themes can be changed in the Settings Menu.
The Standard theme resembles a classic analog dial face, with a traditional speedometer design.
For a more modern look, the Analog Sport theme displays the speedometer as a numeric value rather than a meter.
The Bike Information screen displays important information about your vehicle, such as front and rear tire pressure (if equipped), fuel economy and more.
The Ride Information screen displays important ride information, including current ride time, total distance traveled and more.
Maps and Navigation
The Maps and Navigation screen allows access to the many navigation features of RIDE COMMAND. From the Maps and Navigations screen, you can find directions, look up addresses, search for gas stations and pinpoint other points of interest. Once selected, the display will provide turn-by-turn directions to your destination.
You can not plan a route on the app or website and sync it to the display. You must enter a destination directly on the display for start-to-end navigation.
For information on updating map data, read Updating Software and Maps on the 4" Round Touchscreen Display Powered by RIDE COMMAND.
The Music screen allows you to access music stored on your smartphone or other music device. You can pair your device with Bluetooth® or the display’s USB port.
From the Controls screen, you can select your Ride Mode and adjust the display brightness.
Press the App Tray button (1) to cycle through the available app screens.
If the display is connected to a phone using Bluetooth®, the phone screen will be available from the App Tray. From the phone screen, you can make and answer calls and view text messages.
Use the 5-way media switch (1) to do the following:
- Press center to mute.
- Press up/down to increase/decrease volume.
- Press left/right to move to previous/next track.
Use the 3-way select switch (2) to do the following:
- Press up and down to navigate the display screen.
- Press center to select.
There are trigger switches located on the reverse side of both the right and left (3) switch cubes. Use the trigger switches to do the following:
- Press the right trigger switch to confirm the selection.
- Press the left trigger switch to back out of menu screens.
From the Settings Menu you can view important details about your vehicle and personalize your touchscreen display. The Settings Menu contains four categories: Information, General, Time and Vehicle. Press the Controls button (1) to access the Settings Menu. See your Owner’s Manual for more information.
- Vehicle Identification Number (VIN)
- Installed software version
- Oil change interval
- Themes (Day/Night/Auto)
- Manage Bluetooth® devices
- Change the language
- Set the speed units of measure (MPH or KPH)
- Set the temperature units (F or C)
- Update software
- Set the time format (12-hour or 24-hour)
- Enable GPS time (automatically sets the time to the time zone you are currently in)
- Set time (if GPS time is not enabled)
Note: The clock is sourced from the GPS chip and periodically requires GPS lock to function correctly. Clock reading will be non-existent or inaccurate after disconnecting the battery and will require a new GPS sync to function properly.
- Oil life/service reset
- Access vehicle diagnostics
From the display, you can choose between three Ride Modes: Tour, Standard and Sport. For more information on ride modes, read Using Ride Modes on Your Indian Motorcycle.
For information on pairing a mobile device or headset to your display, read Pairing Your Phone to the 4" Round Touchscreen Display Powered by RIDE COMMAND or Pairing Your SENA® Headset.
RIDE COMMAND Account Syncing
If this display is on a Chief, you can now log in to your RIDE COMMAND account with your 4" Round Touchscreen Display powered by RIDE COMMAND to see vehicle health data from the app or website. This feature is not currently available on FTR models.
To log in to your account, follow these steps:
Note: First ensure that your software and maps are up to date. Read Updating Software and Maps on the 4" Round Touchscreen Display Powered by RIDE COMMAND for assistance.
1. Power on the vehicle through the right hand control power button. Do not start the engine.
2. Press the App Tray button at the bottom of the screen and select SETTINGS.
3. Navigate to SETTINGS > GENERAL (gear icon) from the tabs on the top of the screen and select ACCOUNT.
4. Select LOG IN TO YOUR ACCOUNT.
5. Enter your RIDE COMMAND account information, beginning with your email address.
The Indian Motorcycle App is available on the App Store® for iPhone® and iPad®, as well as on Google Play®.
More information about RIDE COMMAND can be found in the Owner's Manual for your vehicle.
Visit the RIDE COMMAND website to create an account and update software/maps.
Not sure what you need? Check out the Guide to Indian Motorcycle Displays Powered by RIDE COMMAND.
Bluetooth® is a registered trademark of Bluetooth Sig, Inc.
Google Play® and YouTube® are registered trademarks of Google LLC
App Store®, iPad® and iPhone® are registered trademarks of Apple Inc.
SENA® is a registered trademark of SENA Technologies, Inc.
Unless noted, trademarks are the property of Indian Motorcycle International, LLC.
© 2022 Indian Motorcycle International, LLC